Power Door Lock Actuator Position Sensor: Service and Repair

Removal
1. Turn ignition key to position II.
2. Motor door glass to fully raised position.
3. Turn ignition key to position 0.
4. Remove battery cover and disconnect ground cable from battery terminal. Service and Repair
5. Remove door casing for access.
6. Remove door primary water shedder.
7. Position PVC secondary water shedder for access.
8. Remove door latch assembly.





9. Slacken and remove latch assembly cover securing screw.





10. Release cover to latch inner locating boss and remove cover.





11. Release door lock/unlock switch securing tang, depress pip and remove switch from latch assembly.
12. Remove and discard switch harness securing tape.
13. Remove harness multiplug pin protector and using special tool MS.1540, release switch terminal pins from multiplug.


Installation
1. Fit and fully seat terminal pins in harness multiplug and fit terminal pin protector.





2. Fit door lock/unlock switch to latch assembly, ensuring that tang and pip are correctly located.
3. Secure switch harness with suitable tape.





4. Fit cover to latch assembly.
Position cover on latch assembly, ensuring that internal boss locates correctly in latch housing.
Fit and tighten cover securing screw.
5. Fit latch assembly to door.
6. Reposition secondary water shedder in door.
7. Fit main water shedder to door.
8. Fit door casing.
9. Connect ground cable to battery terminal and fit battery cover. See Battery Reconnection Procedure. Service and Repair