Center Registers

Removal
1. Remove battery cover and disconnect ground cable from battery terminal.
2. Using a thin plastic lever, carefully remove fascia centre veneer panel from fascia.
3. Remove glove box.







4. Accessing through glove box aperture, disconnect fascia centre vent harness multiplug.







5. Exercising care to avoid damaging surfaces, use a thin plastic lever to release centre vent dowels from fascia.
6. Positioning vent for access, move vent lead and multiplug clear of fascia harness and remove vent from fascia.

Installation
1. Position centre vent at fascia and route harness multiplug to fascia location.
2. Finally position vent and fully seat dowels in fascia.
3. Accessing through glovebox aperture, connect centre vent multiplug to fascia harness.
4. Fit and fully seat centre vent veneer panel.
5. Fit glovebox.
6. Connect ground cable to battery terminal and fit battery cover.