Headliner

Headliner (76.64.01)

Removal

1. Remove front seats.
2. Remove rear seat cushion and squab.
3. Remove battery cover and disconnect earth cable from battery terminal.
4. Remove rear quarter casings.
5. Remove combined grab handles and coat hanger hooks.
6. Remove 'J' gate surround.
7. Remove center console.
8. Remove 'A' post upper trim panels.
9. Remove sun visors.
10. Remove sun visor retention bezels.
11. Remove roof console.
12. Withdraw each door aperture seal from flange upper section.







13. Position headlining for access.
- Easing the body tabs back to release the headlining, progressively move the headlining downwards to access interior light multiplug.
- Disconnect interior light multiplug and free headlining from remaining body tabs.







14. Avoiding damage to fascia, door aperture seals and door casings, lift and turn headlining through 90 degrees, tilt into passenger footwell and remove from vehicle.







15. Remove interior light from headlining.

Installation

1. Fit interior light to headlining.
2. Place headlining in vehicle tilted to position with one end in footwell and opposite end at top of door aperture.
3. Lift and rotate headlining through 90 degrees.
4. Position headlining at roof and reposition door aperture seals to retain it.
5. Connect interior light multiplug.
6. Fully seat headlining ensuring correct positioning over backlight flange.
7. Bend body tabs into position to secure headlining.
8. Fit roof console.
9. Fit both sun visors.
10. Fit 'A' post upper trim panels.
11. Fit center console assembly.
12. Fit 'J' gate surround.
13. Fit combined grab handles and coat hanger hooks.
14. Fit rear quarter casings.
15. Fit rear seat squab and cushion.
16. Connect earth cable to battery terminal and fit battery cover.
17. Fit front seats.