Overhead Console

Overhead Console (76.13.69)

Removal

1. Remove battery cover and disconnect ground cable from battery terminal.
2. Commencing at rear and exercising care to avoid damaging headlining, use a thin plastic lever to release the three spring clips securing console to roof.







3. Disconnect roof console harness connector and remove console from vehicle.







4. NOTE: The only serviceable item in the roof console is the garage door remote switch fitted for certain markets. Both types of console are supplied as complete assemblies.

Remove three screws and release strap securing switch assembly to roof console.







5. Disconnect switch harness connector and remove switch assembly from console.







Installation

1. Position garage door remote switch on console and connect harness connector.
2. Install but do not tighten switch front securing screw.
3. Install securing strap and screws.
4. Install all switch securing screws.
5. Position console at roof and connect harness connector.
6. Ensuring harness is correctly positioned, press console firmly upwards to fully seat spring clips.
7. Connect ground cable to battery terminal and install battery cover.