Passenger Side Floor Covering

Passenger Side Floor Covering (76.49.10)

Removal

1. Remove battery cover and disconnect ground cable from battery terminal.
2. Remove door sill treadplate.
3. Remove front passenger seat.
4. Remove 'J' gate surround.
5. Remove centre console for access.
6. Remove rear quarter casing for access.
7. Remove rear seat cushion.
8. Remove 'A' post lower trim pad.
9. Remove 1/4 turn toeboard fastener.







10. Remove and discard fastener securing carpet at facia/console area.







11. Withdraw draught welt and release carpet retaining clips from door aperture flange.







12. Free rear of carpet from rear seat cushion locater.
13. Lift rear of carpet and pass seat harness and connector through.







14. Fold front of carpet back from footwell.
15. Ensuring carpet is free, pull rearwards and remove it from vehicle.

Installation

1. Position carpet in vehicle.
2. Align carpet with toeboard.
3. Align carpet with heelboard and secure with clip.
4. Install carpet to door aperture retaining clips.
5. Install and fully seat draught welt on door aperture flange.
6. Install new fastener securing carpet to fascia/console area.
7. Install fastener securing carpet to toeboard.
8. Install 'A' post lower trim pad.
9. Install rear seat cushion.
10. Install rear quarter casing.
11. Install centre console.
12. Install 'J' gate surround.
13. Install passenger seat and adjust to original position.
14. Install door sill treadplate.
15. Connect ground cable to battery terminal and install battery cover.