Driver Side Floor Covering

Driver Side Floor Covering (76.49.09)

Removal

1. Remove battery cover and disconnect ground cable from battery terminal.
2. Remove door sill treadplate.
3. Remove driver seat.
4. Remove 'J' gate surround.
5. Remove centre console for access.
6. Remove rear quarter casing for access.
7. Remove rear seat cushion.
8. Remove 'A' post lower trim pad.
9. Exercising care, use a thin blade to release footrest tangs and spigots from mounting plate.







10. Remove footrest mounting plate securing bolts and remove mounting from vehicle.







11. Slacken and remove toeboard fastener.







12. Release carpet from around kickdown switch and toeboard area.







13. Remove and discard fastener securing carpet at fascia/console area.







14. Remove handbrake lever trim and ensure that lever is left in fully upright position.
15. Withdraw draught welt and release carpet retaining clips from door aperture flange.







16. Free rear of carpet from rear seat cushion locater.
17. Lift rear of carpet and pass seat harness and connector through.







18. Fold front of carpet back from footwell.
19. Lift carpet over handbrake lever, ensuring carpet is free, pull rearwards and remove it from vehicle.

Installation

1. Position carpet in vehicle fitting it over handbraken lever.
2. Align carpet with toeboard and kickdown switch.
3. Install carpet to door aperture retaining clips.
4. Install and fully seat draught welt on door aperture flange.
5. Install cover on handbrake lever.
6. Position carpet over rear seat cushion locater.
7. Install and fully seat new fastener securing carpet to fascia/console area.
8. Install fastener securing carpet to toeboard.
9. Position driver footrest mounting bracket and install securing bolts.
10. Install driver foot rest on mounting bracket.
11. Install 'A' post lower trim pad.
12. Install rear seat cushion.
13. Install rear quarter casing.
14. Install centre console.
15. Install 'J' gate surround.
16. Install driver seat and adjust to original position.
17. Install door sill treadplate.
18. Connect ground cable to battery terminal and install battery cover.