Trunk / Liftgate Interior Trim Panel: Service and Repair

Luggage Compartment Lid Moulding (76.43.79)

Removal

1. Slacken and remove trunk stowage strap securing screw and remove strap.







2. Release eight fasteners securing the insulating pad to rear of the trunk lid and position pad for access.







3. Disconnect number plate lamp harness multiplugs.







4. Slacken and remove the four trim finisher/number plate lamp assembly securing nuts and remove assembly from trunk lid.







5. Remove lenses and bulb holders and discard gaskets from number plate lamps.







Installation

1. Fit new gaskets to number plate lamps.
2. Fit and fully seat bulb holders and lenses to number plate lamps.
3. Position trim finisher/number plate lamp assembly on trunk lid and fit and tighten the securing nuts.
4. Connect number plate lamp harness multiplugs.
5. Re-position insulation pad on trunk lid and fit and fully seat fasteners.
6. Position trunk stowage strap and fit and tighten securing screw.