Interior - Door Trim Panel loose

XK

501-57

DATE: 09/05

MODEL:
2000 MY-ON
XK Range

VIN:
A00016-ON

Door Trim Panel Loose or Adrift - Upper Rear Retainer Clip Bracket - Repair

Issue:

Some vehicles may exhibit a door trim panel that is loose due to a broken upper rear retainer clip bracket. The bracket can be renewed, to avoid replacing the complete trim panel.

Action:

In case of a verified customer complaint of the above condition, do not replace the door trim panel. Install a new retainer clip bracket on the door trim panel as outlined below.

1. Remove the door trim panel (see Global Technical Reference GTR Workshop Manual, section: 501-05).





2. Using a suitable pen, draw a line around the damaged retainer clip bracket (Illustration 1).

Caution:
Ensure the door trim panel is not damaged by removing the retainer clip bracket.





3. Carefully pry the damaged retainer clip bracket from the door trim panel, using a suitable flat bladed tool (Illustration 2).

4. Apply 3M Hotmelt 3748 Adhesive (or a suitable Polyolefin adhesive) to the marked area on the door trim panel.





5. Install the new retainer clip bracket to the door trim panel (Illustration 3).

6. Install the door trim panel (see Global Technical Reference GTR Workshop Manual, section: 501-05).

Global Technical Reference (GTR) Workshop Manual Information:

Internet access: http://www. Jaguartechinfo.com





Parts Information

Warranty Information:





Warranty claims should be submitted quoting the information found in the table.

This will result in payment of the stated time and, where applicable parts/miscellaneous expense codes as listed.

Note:
3M Hotmelt 3748 Adhesive is classed as a workshop consumable and should be locally sourced.





Disclaimer