Radio, Stereo, and Compact Disc: Service and Repair

Audio Unit Housing (76.25.15)

Removal

1. Remove battery cover and disconnect earth lead from terminal.
2. Remove 'J' gate surround.
3. Remove center console assembly for access.
4. Slacken and remove the six radio console securing screws and partially withdraw the console for access.







5. Disconnect radio assembly.
- Disconnect console harness multiplugs and aerial co-axial connector.
- Slacken and remove nut securing earth lead to radio and remove lead from stud.
- Disconnect radio harness multiplug and position harness clear of center console.







6. Remove radio.
1. Withdraw radio console, remove radio from console and remove radio retaining plate.







7. Remove air conditioning control module.
- Slacken and remove the three air conditioning control module securing screws and remove the module.







8. Remove center console switch module.
- Releasing end locaters, lightly press switch module out of console.







9. Remove radio console from vehicle.

Installation

1. Connect aerial co-axial lead to radio and stow excess harness and lead lengths in radio mounting aperture.
2. Fully seat radio in console, ensuring that harnesses and leads do not obstruct.
3. Position and locate switch module in console.
4. Position the air conditioning control module in the console and fit and tighten the three securing screws.
5. Fit radio retaining plate on the console.
6. Holding radio console in position, route radio harness multiplugs into center console.
7. Connect radio harness and radio console harness multiplugs.
8. Route earth and aerial leads through radio console.
9. Finally position radio console and fit and tighten the six securing screws.
10. Fit earth lead to the radio stud and fit and tighten securing nut.
11. Connect aerial lead to radio.
12. Ensuring harness and leads do not obstruct, push radio fully home.
13. Fit center console.
14. Fit 'J' gate surround.
15. Connect earth cable to battery terminal and fit battery cover.