Audio Unit, Removal

Removal
1. Remove battery cover and disconnect earth lead from terminal.
2. Remove 'J' gate surround. Service and Repair
3. Move gear selector to 'D'
4. Remove center console assembly for access. Service and Repair






5. Remove the six radio console securing screws and partially withdraw the console for access.







6. Disconnect radio assembly.
Disconnect console harness multiplugs and aerial co-axial connector.
Slacken and remove nut securing earth lead to radio and remove lead from stud.
Disconnect radio harness multiplug and position harness clear of center console.







7. Remove radio.
Release spring retaining clips, remove radio from console and remove radio from mounting console.

Installation

1. Slide radio into mounting panel and position at console for access
2. Connect aerial co-axial lead to radio and stow excess harness and lead lengths in radio mounting aperture.
3. Fully seat radio in console, ensuring that harnesses and leads do not obstruct.
4. Install radio mounting panel on the console.
5. Holding radio console in position, route radio harness multiplugs into center console.
6. Connect radio harness and radio console harness multiplugs.
7. Route earth and aerial leads through radio console.
8. Finally position radio console and fit and tighten the six securing screws.
9. Position ground lead on radio stud and install securing nut.
10. Connect aerial lead to radio.
11. Ensuring harness and leads do not obstruct, push radio fully home.
12. Install center console. Service and Repair
13. Return gear selector to 'P'
14. Fit 'J' gate surround. Service and Repair
15. Connect earth cable to battery terminal and fit battery cover.