RH Side

Removal
1. Open hood and install cover on adjacent front fender.





2. Remove headlamp rear trim cover panel.





3. Disconnect harness multiplug from headlamp levelling actuator.





4. Rotate actuator 1/4 turn, tilt forward end downward and withdraw assembly from headlamp.


Installation
1. With forward end tilted downward, position actuator assembly on headlamp.
2. Align actuator with headlamp and rotate it 1/4 turn to engage and fully seat.
3. Connect harness multiplug to actuator.
4. Install rear trim cover panel on headlamp.
5. Carry out headlamp beam alignment to the appropriate alignment equipment instructions.
6. Remove front fender cover and close hood.