Door Opening Lower Weatherstrip - Vehicles Without: Convertible Top

Door Opening Lower Weatherstrip - Vehicles Without: Convertible Top (76.40.30)

Removal

1. Remove the draught welt.
1. Remove the treadplate finisher and place face uppermost on sheet of clean dry polythene.
2. Slacken and remove treadplate securing screws and remove treadplate.
3. Remove front of welt from aperture flange.
4. Withdraw rear draught welt section from aperture flange.







2. Remove the door aperture seal.
1. Remove the three fasteners securing seal to 'A' post and cut through Alphaseal.
2. Remove fastener securing seal to 'B' post.
3. Remove seal complete with rear draught welt section from door aperture.







Installation

1. Fit door aperture seal.
1. Position seal on 'A' post and fitting lower one first, secure with three fasteners.
2. Fit and firmly seat seal in aperture channel.
3. Secure to 'B' post with fastener.
- Apply Alphaseal.







2. Fit draught welt section.
1. Fit and fully seat rear draught welt section over aperture flange.
2. Fit and fully seat front welt section over aperture flange aligning end with panel joint.
3. Position sill tread plate and fit and tighten three securing screws.
4. Fit treadplate finisher. If finisher has been renewed, remove protective film.