Front Seat (Underside and Upper Frame)

Seats

Front Seat (Underside And Upper Frame)







The driver and passenger seat control modules (DSM and PSM) which control seat and squab movement, and seat heating where fitted, are mounted on brackets below the seat frames and are connected to the SCP network.

Seat movement control switch assemblies fitted in the outboard side of both the driver and front passenger seats, are color keyed to the seats. These switches, through the seat control modules, operate motors for fore and aft, recline and raise and lower movements of the seat. On some markets/options, another motor operates the lumbar adjustment pump which is also controlled by a switch mounted in the seat. Only one of the slide, recline or height motor outputs can be driven at any one time under manual control. Additionally, some markets/options have passenger seat height adjustment, seat and squab heaters and driver's seat position memory.

On cars fitted with driver seat memory, each motor is fitted with feedback potentiometers. The illuminated on/off switches for seat heating where fitted as options or standard fit in cold climate territories, are mounted in the center console. Rear passenger access/egress is made easier by a lever mounted on the upper outside of driver and passenger seats allowing the seat squabs to fold forward. Each front seat has a rear map pocket.

The rear seats are wire-framed units trimmed to match the front seats and specifically tailored to fit either the coupe or the convertible. No adjustment of the rear seats is provided. Provision is made for the fitting of child seats where legally required.