Power Trunk / Liftgate Lock Switch: Service and Repair

Luggage Compartment Lid Release Switch (86.25.56)

Removal

1. Remove trunk lamp assemblies.
2. Remove covers from the two trunk latch finisher securing bolts and slacken and remove bolts.







3. Remove latch finisher from trunk.
4. Remove and discard the four fasteners securing rear of trunk lid liner and position liner for access.







5. Release trunk release button harness connector from retaining clip and disconnect connector.







6. Slacken and remove the trunk upper trim finisher securing nuts.







7. Position upper trim finisher for access and withdraw release button harness grommet from trunk lid aperture.







8. Position upper trim finisher for access and slacken and remove release button securing screws.







9. Withdraw release button assembly from trim finisher.

Installation

1. Position trunk release button assembly on trim finisher and install securing screws.
2. Position trim finisher/release button assembly at trunk lid and route harness through lid aperture.
3. Position grommet over harness and install in trunk lid aperture.
4. Position trim finisher/release button assembly on trunk lid and install securing nuts.
5. Connect release button harness connector and install on retaining clip.
6. Reposition rear of trunk lid liner and secure with new fasteners.
7. Position lock finisher and install securing bolts.
8. Install covers over finisher securing bolts.
9. Install trunk lights.