Radio Console

RADIO CONSOLE


Removal
1. Remove centre console veneer panel. Centre Console Veneer Panel
2. Withdraw radio from console for access, disconnect multiplugs and aerial lead and remove radio from vehicle.







3. Remove console for access.
1. Slacken and remove two screws securing radio console to fascia, release two dowels and withdraw console for access.
2. Release clip retaining air conditioning panel harness.
4. Tilt bottom of radio console upwards and remove console from vehicle.

Installation
1. Position radio console for access and secure air conditioning harness in LH clip behind console.
2. Fit console to BIW and fit and tighten securing screws.
3. Position radio at console and connect multiplugs and ground and aerial leads.
4. Fully seat radio in console.
5. Fit centre console veneer panel. Centre Console Veneer Panel
6. Fit 'J' gate finisher retaining panel. 'J' Gate Finisher Retaining Panel
7. Fit 'J' gate finisher. 'J' Gate Finisher
8. Connect ground cable to battery terminal and fit battery cover.