Overdrive Switch: Service and Repair

Drive to 4th Selector Switch

Removal

1. Open the drivers door, or both doors if necessary, to allow the side glass to drop. Ensure that the doors remain open until after the battery has been disconnected.





2. Disconnect battery ground cable.
Remove the battery cover.
3. Remove the gear shift knob.
4. Remove the console finisher veneer panel.
5. Remove the 'J Gate' surround for access.





6. Remove the D to 4 switch.
Press the retaining tangs to release.

Installation

1. Fitting a new D to 4 switch is the reverse of the removal procedure.
2. Perform the Battery Reconnection Procedure described in Starting and Charging.