Engine Control Module: Service and Repair

Removal
1. Disconnect battery ground cable. Service and Repair





2. Remove ECM housing cover.
3. Disconnect electrical connectors.





4. Lift ECM from housing.


Installation
1. Installation is a reversal of the removal procedure. See Battery Reconnection Procedure. Service and Repair

NOTE: A replacement ECM may only be obtained from an authorized Jaguar dealer and MUST be ordered against the VIN.

NOTE: Check condition of housing seals and replace as necessary.

2. Synchronize ECM, KTM and BPM using PDU.
3. Complete engine set-up using JDS/PDU.