Transmitter Programming Trouble-Shooting

If the GDO transmitter does not program to your hand held transmitter, re-read the instructions carefully and repeat the steps. It still unsuccessful, read the following important details:

^ Check that the batteries in the hand held transmitter are not dead.

^ Hold the hand held transmitter in the precise position shown in the illustration.

^ Press and hold the two buttons, without interruption, for the duration of the programming.

^ Turn the hand held transmitter round and reprogram using the opposite end. For the best results use the opposite end to the battery compartment when programming.

To erase previously programmed frequencies:
Press and hold buttons 1 and 4 until the red light marked "GARAGE" begins to flash. This will erase all four channels. Individual channels cannot be erased, but can be reprogrammed at any time by conducting the programming procedures over again.

This appliance complies with Part 15 of the USA Federal Communications Commission (FCC) rules. Operation is subject to the following two conditions:

1. The devices may not cause harmful interference.

2. The devices must accept any interference received including interference that may cause undesired operation.

Caution:
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.