Input Shaft Sensor Replacement

REMOVAL

NOTE: For INPUT see step #4, for OUTPUT refer to step #6; the procedures differ only in location within the transmission assembly.

1. Disconnect the battery ground lead.

WARNING: TRANSMISSION FLUID MAY CAUSE SEVERE BURNS, ENSURE THAT ALL SAFETY PROCEDURES ARE OBSERVED.

2. Raise the vehicle on a suitable lift.





- Carefully remove the drain plug and drain the transmission fluid.





3. Remove fluid pan fixings (22).
- Remove the fluid pan & all traces of gasket material.

NOTE: M5 fixing





4. Release the fixing (1) INPUT speed sensor securing bracket and pull the sensor clear.

OR





5. Release the fixing (1) INPUT speed sensor securing bracket and pull the sensor clear.

NOTE: M6 fixing

6. Release the fixing (1 ) OUTPUT speed sensor securing bracket and pull the sensor clear.





7. Disconnect the relevant speed sensor multiplug.

INSTALLATION

NOTE: M5 fixing





1. Connect the multiplug, install the INPUT speed sensor and securing bracket.

OR





2. Connect the multiplug, install the INPUT speed sensor and securing bracket.

NOTE: M6 fixing

3. Connect the multiplug, install the OUTPUT speed sensor and securing bracket.

NOTE: Ensure extreme cleanliness and never reuse transmission fluid





4. Using a new gasket, install the fluid pan and tighten the fixings (22) as specified.
5. Refer to General Procedures for fluid fill.