Output Speed Sensor

OUTPUT SPEED SENSOR, RENEW

- Raise the vehicle on a ramp.

- Reposition the edge of the transmission tunnel sound insulation foam for access.

- Disconnect the harness plug from the output speed sensor.

- Release and remove the speed sensor securing bolt.

- Reposition the speed sensor protection cover for access, noting that the cover remains captive on the harness.

- Remove the speed sensor from the transmission unit and place aside.

- Clean the main case speed sensor area.

- Fit a new '0' ring seal to a new output speed sensor.

- Lubricate the '0' ring seal.

- Fit and seat the speed sensor to the main case.

- Reposition and align the speed sensor protection cover.

- Fit and tighten the speed sensor securing bolt.

- Connect the harness plug to the speed sensor.

- Reposition the edge of the transmission tunnel sound insulation foam to the original position.

- Lower the vehicle on the ramp.