Remove & Refit

- Remove engine cover.
- Disconnect air conditioning compressor lock sensor multi-plug.
- Disconnect 'B' Bank injector multi-plugs.
- Disconnect throttle potentiometer harness multi-plug.
- Disconnect engine oil pressure transmitter harness multi-plug.
- Disconnect engine position sensor harness plug.
- Disconnect compressor clutch harness multi-plug.
- Disconnect 'A' Bank injector multi-plugs.
- Disconnect 'A' & 'B' Bank ignition coils.
- Disconnect fuel rail temperature sensor harness multi-plugs.
- Disconnect Power Assisted Steering (PAS) high pressure hose switch multi-plug.
- Disconnect generator multi-plug.
- Disconnect crankshaft sensor harness multi-plug.
- Partial drain coolant.
- Remove right-hand headlamp and relay cover.
- Remove right-hand air cleaner element and assembly.
- Remove idler pulley assembly.
- Disconnect right-hand idle speed control valve harness multi-plug.
- Disconnect water temperature sensor harness multi-plug.
- Remove left-hand headlamp and relay cover(s).
- Disconnect right-hand air temperature sensor.
- Disconnect starter motor link lead harness multi-plug.
- Disconnect right-hand oxygen sensor multi-plug.
- Disconnect right-hand manifold pressure sensor multi-plug.
- Disconnect engine speed sensor multi-plug.
- Disconnect left-hand manifold pressure sensor.
- Disconnect vacuum solenoid valve from below the left-hand inlet manifold.
- Disconnect oxygen sensor multi-plug.
- Disconnect left-hand water temperature sensor multi-plug.
- Remove left-hand headlamp and relay cover (5).
- Remove left-hand air cleaner element and assembly.
- Disconnect left-hand and forward side harness multi-plugs.
- Disconnect 'A' and 'B' bank purge valve multi-plugs.
- Disconnect air conditioning dual pressure switch multi-plug.
- Remove tool box assembly.
- Remove wiper blade, plenum chamber grill and disconnect washer jet supply hose.
- Disconnect washer jet multi-plugs
- Disconnect brake signal harness multi-plug.
- Disconnect 'A' and 'B' bank ignition control module multi-plugs.
- Disconnect fuel injection harness multi-plug.
- Remove ignition coil relay from right-hand inner wing valance mounting bracket.
- Disconnect air con. clutch, ignition and fuel injection main relays from the mounting bracket.
- Disconnect barometric pressure sensor multi-plug.
- Remove drivers side under scuttle pad and 'A' Post lower trim pad.
- Remove control module-combined ignition and injection.
- Remove footwell outlet duct.
- Disconnect fuel injection to console harness.
- Remove harness assembly and refit repaired or new harness in revers order removal procedures.