Remove & Refit

- Remove engine cover.
- Remove intercooler intake elbow.
- Remove air cleaner element and assembly.
- Disconnect EGR harness multi-plug.
- Disconnect on plug coil harness multi-plug
- Disconnect starter motor solenoid harness multi-plug.
- Disconnect oxygen sensor harness multi-plug.
- Disconnect coolant thermistor harness multi-plug.
- Disconnect water temperature sensor connector.
- Disconnect engine position sensor harness plug.
- Disconnect compressor clutch harness multi-plug.
- Disconnect crankshaft sensor harness multi-plug.
- Disconnect air pump harness multi-plug.
- Disconnect air flow meter harness multi-plug.
- Disconnect purge valve harness multi-plug.
- Disconnect side harness multi-plugs.
- Disconnect supercharger coolant pump harness plug.
- Disconnect generator harness multi-plug.
- Disconnect injector harness multi-plug.
- Remove right-hand headlamp cover.
- Disconnect air conditioning pressure switch harness multi-plug.
- Disconnect upstream oxygen sensor harness multi-plug.
- Disconnect right-hand front relay bases from brackets and remove relays.
- Disconnect harness to side harness multi-plug.
- Disconnect barometric pressure sensor harness multi-plug.
- Remove tool box assembly.
- Remove wiper blade, plenum chamber grill and disconnect washer jet supply hose.
- Disconnect washer jet multi-plugs
- Route washer jet harness through bulkhead to engine bay.
- Disconnect traction control signal harness multi-plug.
- Remove oil filter cartridge and oil filter head gasket.
- Remove rear air duct to throttle body hose.
- Disconnect EGR sensor harness multi-plug.
- Disconnect rear knock sensor harness multi-plug.
- Disconnect idle speed control actuator harness multi-plug.
- Disconnect throttle potentiometer harness multi-plug.
- Disconnect engine oil transmitter harness connector.
- Disconnect air thermistor harness multi-plug.
- Disconnect front knock sensor harness multi-plug.
- Remove under scuttle pad and 'A' post lower trim pad.
- Disconnect ECM multi-plugs.
- Disconnect fuel injection harness to console harness multi-plugs.
- Remove harness assembly and refit repaired or new harness in revers order removal procedures.