Driving Position Set

Setting of seat, column and external rear view mirrors to preferred driving position is available using the memory buttons located on the drivers door switch pack. With the ignition key in place enter settings to be memorized as follows:
Adjust seat, column and mirrors to desired positions.
Press the 'memory' button so that it becomes illuminated. -

Press button 1,2 or 3 to store configuration within four seconds of memory button operation. Memory light will extinguish and a chime will sound, indicating procedure complete.

The above procedure may be repeated two more times until each button (1, 2 & 3) has a preferred position stored in memory, accommodating different driver settings. Operation of any push-button (1, 2 or 3) will re-position seat column and mirrors to the stored settings.

Memory recall will operate under the following conditions:
- Ignition key in and gear selector in park.
- Ignition key in and hand brake on.
- Ignition key out and driver's door open (or having been closed within the last 30 seconds).

Re-setting the preferred position on any setting button automatically erases previously stored information. Memory information is not erased if power supply to the seat and column! mirror control modules is lost (e.g. battery disconnected).