Removal and Installation

Fig. 1:

- Remove the battery cover. Disconnect the battery.
- Remove the console rear extension finisher (Daimler/VDP).
- Remove the console rear extension veneer panel (Daimler/VDP).
- Remove the console rear extension (Daimler/VDP).
- Remove the drivers side underscuttle pad.
- Remove the passenger side underscuttle pad.
- Remove the console ashtray.
- Remove the console finisher veneer panel.
- Remove the radio console.
- Remove the fascia center veneer panel.
- Undo and remove the console upper securing screws.
- Displace and reposition the rear air distribution outlet hex.
- Disconnect the cigar lighter multi-plug (where fitted).
- Undo and remove the center console rear mounting securing screw.
- Displace and remove the console assembly and place on the bench.
- Displace and remove spire clips from console assembly.
- Open the glove box lid.
- Remove the glove box lid latch.
- Undo and remove glove box lid rear securing screws.
- Displace and remove glove box lid/glove box assembly.
- Place the console (Fig.1) aside.

Refit in the reverse order of the removal procedure.