Rear Unit End Play Check 2

^ Tools Required
- J 8001-3 Dial Indicator
- J 8520 Cam Lobe Lift Indicator - Dial Indicator Adapter Set





1. Assemble the J 8520 by attaching the threaded rod and the dial indicator holder to one of the bolt holes on the transmission case.
2. Push in on the output shaft (671) to take up any slack.
3. Mount J 8001-3 on the rod and index it to the end of the output shaft (671).
4. Set the indicator to 0.
5. Move the output shaft (671) in an out noting the amount of endplay.
^ The correct endplay is 0.127 - 0.635 mm (0.005 - 0.025 inch).
^ If the endplay is not correct, change the output shaft selective thrust washer (674). Refer to the Output Shaft Selective Thrust Washer Specifications table found in End Play Specifications under Specifications/Mechanical.

6. Remove the tools from the transmission.