Wiper Motor: Service and Repair
Removal ProcedureTool Required
J 39232 Wiper Transmission Separator
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the transmission from the wiper motor drive link using the J 39232.
4. Disconnect the electrical connector from the wiper motor assembly.
5. Remove the three screws and wiper motor assembly from the vehicle.
Installation Procedure
Tool Required
Wiper Transmission Installer J 39529
NOTE: Refer to Fastener Note in Service Precautions.
1. Install the wiper motor assembly onto the vehicle with three screws.
Tighten
Tighten the wiper motor assembly mounting screws to 6.5 N.m (57 lb in)
2. Connect the electrical connector.
IMPORTANT:
- Lubricate the socket with white lithium grease.
- The wiper transmission assembly must be assembled to the crank arm past the second detent so the seal is compressed to a maximum height of 25.5 mm (1 in).
3. Install the transmission drive link socket onto the crank arm ball of the wiper motor assembly using the Wiper Transmission Installer J 39529.
4. Install the air inlet grille panel.
5. Install the wiper arms.
Inspection Procedure
Perform the System Check.