Fluid - M/T: Service and Repair

Fluid Replacement

Removal Procedure

Tools Required

J 36511 Oil Full Drain Plug Hex Bit (17 MM)

1. Rase the vehicle.




2. Using J 36511 remove the oil fill and drain plugs. Catch the oil in a suitable container.

Installation Procedure




1. Apply sealant to the oil drain plug threads. Use sealant GM P/N 12346004 or the equivalent.
2. Using J 36511 install the oil drain plug.
Tighten
Tighten the oil drain plug to 60 N.m (44 lb ft).
3. Fill the transmission to the level of the fill plug hole.
4. Apply sealant to the oil fill plug threads. Use sealant GM P/N 12346004 or the equivalent.




5. Using J 36511 install the oil fill plug.
Tighten
Tighten the oil fill plug to 60 N.m (44 lb ft).
6. Lower the vehicle.