Band Apply Servo: Service and Repair

2-4 Servo

Removal Procedure

Tools Required
J 29714-A Servo Cover Depressor

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General information.
2. Install the J 29714-A




3. Tighten the bolt in order to compress the servo cover.
4. Remove the servo cover retaining ring.
5. Remove the J 29714-A.




6. Remove the servo cover and the O-ring seal. If the servo cover seems to be hung up on the seal, cut and remove the O-ring seal before removing the cover.
7. Remove the 2-4 servo assembly.

Installation Procedure

Tools Required
J 29714-A Servo Cover Compressor




1. Install the 2-4 servo assembly into the 2-4 servo bore.
2. Install the J 29714-A




3. Tighten the bolt in order to compress the servo cover.
4. Install the servo cover retaining ring.
5. Remove the J 29714-A from the oil pan flange.
6. Install the oil pan bolt.
Tighten
Tighten the oil pan bolt to 11 N.m (97 lb in).
7. Lower the vehicle.
8. Check the automatic transmission fluid level.