Front Shock Absorber

Shock Absorber Replacement (RWD)

Removal Procedure

1. Raise and support the vehicle with safety stands.




2. Remove the shock absorber upper mounting nut. Hold the shock absorber stem with a wrench while backing the nut off.
3. Remove the retainer.
4. Remove the grommet
5. Remove the shock absorber lower mounting bolts.
1. Pull the shock absorber out of the spring from below.
2. The lower grommet and the retainer are on the stem.
3. Replace the parts as necessary.
6. Remove the nuts, if damaged or worn.

Installation Procedure

1. Install the retainer and the grommet on the stem. Fully extend the stem.




2. Install the shock absorber up through the lower control arm and the spring. Insert the stem end through the hole in the upper control arm frame bracket.
3. Install the grommet to the stem.
4. Install the retainer to the stem.
5. Install the shock absorber upper nut.
Tighten
Tighten the shock absorber upper nut to 12 N.m (106 lb in), while holding the stem with a wrench.
6. Install new nuts, if needed.
7. Install the shock absorber lower bolts through the pivot holes to the lower control arm holes.
Tighten
Tighten the shock absorber lower bolts to 30 N.m (22 lb ft).
8. Lower the vehicle.