Coil Spring

Front Coil Springs Replacement

Removal Procedure

Tools Required

- J 23028-01 Coil Spring Remover and Installer

1. Remove the shock absorber.




2. Remove the stabilizer shaft from the lower control arm.




3. Cradle the inner control arm bushings using J 23028-01.
4. Raise the jack in order to relieve tension on the lower control arm pivot bolts.

Important: The chain is not to take place for safety, but to retain the coil spring to the upper control arm.




5. Secure the spring with a chain around one of the top spring coils to the upper control arm.




6. Turn the steering wheel to one side in order to allow the steering Linkage to clear the lower control arm front pivot bolt.
7. Remove the lower control arm pivot bolts and nuts.
1. Take the lower control arm rear pivot bolt out.
2. Take the lower control arm front pivot bolt out.
8. Lower the control arm by lowering the jack.
9. When compression is removed from the coil spring, take the chain away.




10. Remove the coil spring and the insulators. While removing the coil spring, do not apply force to the lower control arm and ball joint.
11. Position the coil spring properly for easy removal.

Installation Procedure

Tools Required

- J 23028-01 Coil Spring Remover and Installer




1. Install the coil spring and the insulators on the lower control arm.
Ensure that coil spring covers all or part of one inspection drain hole. The other hole must be partly or completely uncovered. Rotate coil spring as necessary.




2. Support the control arm using J 23028-01.
3. Position the coil spring and insulator in the upper spring seat on the frame.
4. Raise the lower control arm using J 23028-01.
5. Install the lower control arm to the frame.




6. In order to maintain adequate steering Linkage clearance, install the bolts in the direction shown.
7. Install the lower control arm front pivot bolt and the new nut.
8. Install the lower control arm rear pivot bolt and the new nut.
Tighten
1. Tighten the lower control arm pivot bolts nuts with the front suspension loaded.
2. Tighten the lower control arm front bolt to 115 N.m (85 lb ft).
3. Tighten the lower control arm rear bolt to 98 N.m (72 lb ft).




9. Install the stabilizer shaft to the lower control arm.
10. Install the shock absorber.
11. Remove J 23028-01.
12. Check the front wheel alignment.