Starter Motor: Service and Repair
Removal ProcedureCAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the battery negative cable.
2. Raise and suitably support the vehicle.
3. Remove the front tire and wheel assembly from the right side of the vehicle.
4. Remove the differential carrier shield mounting bolts, if equipped.
5. Remove the differential carrier shield, if equipped.
6. Remove the wires from the solenoid.
7. Remove the starter mounting bolts by accessing them below the right wheel house panel.
8. Remove the starter from the vehicle. Note the location of the shims, if equipped.
Installation Procedure
1. Install the starter and the inboard starter mounting bolt. Do not tighten.
2. Install the starter shims, if equipped.
NOTE: Refer to Fastener Note in Service Precautions.
3. Install the outboard starter mounting bolt.
Tighten
Tighten the starter mounting bolts to 50 N.m (37 lb ft).
4. Connect the wires to the solenoid.
Tighten
- Tighten the battery positive cable nut to 9 N.m (80 lb in).
- Tighten the engine wiring harness to starter nut to 1.9 N.m (17 lb in).
5. Install the differential carrier shield, if equipped.
6. Install the differential carrier shield mounting bolts, if equipped.
Tighten
Tighten the differential carrier bolts to 25 N.m (18 lb ft).
7. Install the tire and wheel assembly.
8. Lower the vehicle.
9. Connect the negative battery cable.