Rear

EVAP System Hoses/Pipes Replacement (Rear)




Removal Procedure

Tool Required:
J 34730-1A Fuel Pressure Gauge

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure.
3. Drain the fuel tank.
4. Raise the vehicle.
5. Clean all the fuel and EVAP pipe connections and the surrounding areas before disconnecting in order to avoid possible contamination of the fuel system.
6. Remove the fuel tank.
7. Disconnect the rear EVAP pipe from the chassis EVAP pipe (1).
8. Remove the EVAP pipe from the retainers.
9. Cap the fuel and EVAP pipes in order to prevent possible fuel system contamination.




Installation Procedure
1. Remove the caps from the fuel and EVAP pipes.
2. Connect the rear EVAP pipe to the chassis EVAP pipe (1).
3. Install the EVAP pipe into the retainers.
4. Install the fuel tank.
5. Lower the vehicle.
6. Refill the fuel tank.
7. Tighten the fuel filler cap.
8. Connect the negative battery cable.
9. Inspect for leaks.
1. Turn the ignition switch ON for 2 seconds.
2. Turn the ignition switch OFF for 10 seconds.
3. Turn the ignition switch ON.
4. Inspect for fuel leaks.