Air Injection Control Valve: Service and Repair
REMOVAL1. Raise the vehicle.
2. For a 2WD vehicle, skip steps 5 and 6.
For a 4WD vehicle, skip steps 3 and 4.
3. Remove the AIR shield mounting bolts.
4. Remove the AIR shield.
5. Remove the retaining bolts from the steering Linkage shield.
6. Remove the steering Linkage shield.
7. Disconnect the vacuum hose (i) from the shut-off valve (2).
8. Disconnect the shut-off valve hose (1) from the AIR pump by releasing the spring clamp.
9. Disconnect the reactor pipe assembly from the reactor pipes by releasing the spring clamps.
10. Remove the reactor pipe assembly.
INSTALLATION
1. Connect the reactor pipe assembly to the reactor pipes by installing the spring clamps.
2. Install the vacuum hose (1) to the shut-off valve(2).
3. Connect the shut-off valve hose (1) to the AIR pump by installing the spring clamp.
4. For a 2WD vehicle, skip steps 7 and 8. For a 4WD vehicle, skip steps 5 and 6.
5. Align the AIR shield.
6. Install the AIR shield mounting bolts.
Tighten
Tighten the bolts to 33 N.m (24 lb ft).
7. Align the steering Linkage shield.
8. Install the Linkage shield mounting bolts.
Tighten
Tighten the bolts to 33 N.m (24 lb ft).
9. Lower the vehicle.