Underhood Lamp: Service and Repair

Removal Procedure

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the battery negative cable.
2. Disconnect the electrical connector.
3. Remove/disconnect the following components from the hood:
- The screw
- The star washer
- The ground wire
4. Remove the screws that retain the underhood lamp to the hood.
5. Remove the underhood lamp assembly from the vehicle.

Installation Procedure




1. Install the underhood lamp assembly to the vehicle.

NOTE: Refer to Fastener Note in Service Precautions.

2. Install the screws that retain the underhood lamp to the hood.

Tighten
Tighten the screws to 1.9 N.m (17 lb in).

3. Connect/install the following components to the hood:
- The ground wire
- The Washer
- The screw

Tighten
Tighten the screws to 1.9 N.m (17 lb in).

4. Connect the electrical connector.
5. Install the bolt that retains the horn assembly to the fender.
6. Connect the battery negative cable.