Double Offset Joint

1. Remove DOJ inner and outer boot clamps then slide boot towards Birfield Joint assembly.

Fig. 1 Ball From Joint Removal:

2. Remove circular clip and withdraw shaft, then using a screwdriver, remove six balls, Fig. 1.
3. Rotate case half a pitch to ensure ball guide aligns with projected portion of ball retainer, then slide towards boot to remove.

Fig. 2 Ball Retainer & Guide Replacement:

Fig. 12 Removing or installing snap ring:

4. Remove snap ring holding ball retainer on center shaft, then the ball retainer along with cage and boot, Figs. 2 and 3.
5. Inspect all parts for abnormal wear, cracks and damage.