Removal and Installation

REAR SPOILER

Removal and Installation


REMOVAL

1.Remove trunk lid trim. Refer to "Removal and Installation" Removal and Installation.





2.Disconnect harness connector (A) of high-mounted stop lamp.
3.Disconnect harness connector (B) of rear view camera.
4.Remove bolt (C).





5.Remove rear spoiler mounting nuts (A).
6.Release rear spoiler connection between trunk lid panel and rear spoiler, using a remover tool, and take off double-faced adhesive tape.
7.Disengage rear spoiler mounting clip, and then disconnect grommets of high-mounted stop lamp harness and rear view camera harness.
8.Remove rear spoiler.
9.Remove following parts after removing rear spoiler.
- High-mounted stop lamp. Refer to "WITH REAR SPOILER : Removal and Installation" Removal and Installation.
- Rear view camera. Refer to "Removal and Installation" With Navigation.
- Rear spoiler clip and grommet.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Be careful not to damage the body.
- Never let air between contact surfaces when installing.
- Never wash vehicle within 24 hours after installation.