Removal and Installation

REAR PARCEL SHELF FINISHER

Removal and Installation


REMOVAL

1.Remove trunk front finisher upper (without REAR SPOILER). Refer to "Removal and Installation" Removal and Installation.





2.Disconnect high-mounted stop lamp harness connector (A).
(without REAR SPOILER)
3.Remove rear seat cushion and rear seatback. Refer to "Removal and Installation" Removal and Installation.
4.Remove rear side finisher and rear pillar finisher. Refer to "Removal and Installation" Removal and Installation.





5.Remove rear parcel shelf finisher fixing clips (A).
6.Remove rear seat striker cover fixing pawls, and then remove rear seat striker cover.
7.Pull rear parcel shelf finisher, and then remove rear parcel shelf finisher.
8.Remove the following parts after removing rear parcel shelf finisher.
- Child anchor cover.
- Rear speaker grille.
- High-mounted stop lamp (without REAR SPOILER). Refer to "WITHOUT REAR SPOILER : Removal and Installation" Removal and Installation.

INSTALLATION

Note the following item, and then install in the reverse order of removal.

CAUTION:
When installing, check in advance that clips and pawls are accurately aligned with the holes on body panel, and then install by pressing in.