Removal and Installation

TRANSVERSE LINK

Removal and Installation


REMOVAL

1.Remove tires with power tool. Refer to "Exploded View" Exploded View.
2.Remove engine lower cover with power tool. Refer to "Exploded View" Exploded View.
3.Remove stabilizer connecting rod. Refer to "Exploded View" Exploded View.
4.Remove steering outer socket from steering knuckle. Refer to "Exploded View" Exploded View.
5.Remove transverse link from steering knuckle. Refer to "Exploded View" Exploded View.
6.Set suitable jack under transverse link.
7.Remove transverse link.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Never tap on the ball joint cap of the stabilizer connecting rod with a hammer or a similar item when inserting the stabilizer connecting rod into the transverse link.
- Perform final tightening of bolts and nuts at the front suspension member installation and shock absorber lower side (rubber bushing), under unladen conditions with tires on level ground.