Maintenance Required Lamp/Indicator: Service and Repair

Resetting The Distance For Changing The Engine Oil





Switches for the trip computer are located on the right side of the combination meter panel. To operate the trip computer, push the side or front of the switches as shown above.

When the ignition switch is pushed to the ON position, modes of the trip computer can be selected by pushing switch A.

Push switch A until the display reads: SETTING.

Switch A and switch B are used in the setting mode to select and decide a menu.

Push switch A to move to the warning check mode.

Note: Warning check mode is available only when a warning is displayed.

Push switch B to select other menus.

There are 5 submenus under the maintenance
menu.
- BACK
Select this submenu to return to the top page of the setting mode.
- ENGINE OIL
Select this submenu to set or reset the distance for changing the engine oil.
- OIL FILTER
Select this submenu to set or reset the distance for replacing the oil filter.
- TIRE
Select this submenu to set or reset the distance for replacing tires.
- OTHER
Select this submenu and set or reset the distance for replacing items other than the engine oil, oil filter and tires.





Select: ENGINE OIL to set or reset the distance for changing the engine oil.