Brake Warning Indicator: Testing and Inspection

BRAKE WARNING LAMP

Description

�: ON -: OFF







Component Function Check


1. BRAKE WARNING LAMP OPERATION CHECK 1

Check that the lamp illuminates for approximately 1 second after the ignition switch is turned ON.
Is the inspection result normal?
YES- GO TO 2.
NO- Proceed to diagnosis procedure. Refer to "Diagnosis Procedure" .

2. BRAKE WARNING LAMP OPERATION CHECK 2

Check that the brake warning lamp in the combination meter turns ON/OFF correctly when operating the parking brake lever (M/T) or the parking brake pedal (A/T).
Is the inspection result normal?
YES- INSPECTION END
NO- Check the parking brake switch. Refer to "Component Inspection" Parking Brake Switch.


Diagnosis Procedure


1. PERFORM SELF-DIAGNOSIS

Perform self-diagnosis for "ABS" with CONSULT.
Is any DTC detected?
YES- Check the DTC.
NO- GO TO 2.

2. CHECK COMBINATION METER

Check if the indication and operation of combination meter are normal. Refer to "Diagnosis Description" Reading and Clearing Diagnostic Trouble Codes.
Is the inspection result normal?
YES- Replace ABS actuator and electric unit (control unit). Refer to "Exploded View" Exploded View.
NO- Repair or replace error-detected parts.


Special Repair Requirement


1. ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

Always perform the neutral position adjustment for the steering angle sensor, when replacing the ABS actuator and electric unit (control unit) or steering angle sensor and removing steering angle sensor. Refer to BRC9, "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : Special Repair Requirement"
- END