Receiver Dryer: Service and Repair

CONDENSER

LIQUID TANK : Removal and Installation


REMOVAL

1.Use a refrigerant collecting equipment (for HFC-134a) to discharge the refrigerant.
2.Remove front grille. Refer to "Exploded View" Exploded View.
3.Clean liquid tank and its surrounding area. Then remove dust and rust from liquid tank.

CAUTION:
Be sure to clean carefully.
4.Remove mounting bolts, and then remove liquid tank.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- Install liquid tank, and then install liquid tank bracket on condenser.
- Check that liquid tank bracket is securely installed at protrusion of condenser. (Check that liquid tank bracket does not move to a position below center of liquid tank.)
- Replace O-rings of the A/C piping with new ones. Then apply compressor oil to them when installing.
- Check for leakages when recharging refrigerant.