Removal and Installation

INTAKE SENSOR

Removal and Installation


REMOVAL

1.Remove low-pressure pipe 1 and high-pressure pipe 2. Refer to "Exploded View" Exploded View.
2.Slide evaporator to passenger side, and then remove intake sensor.
3.Disconnect intake sensor connector.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- Replace O-rings with new ones. Then apply compressor oil to them when installing.
- Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position.
- Female-side piping connection is thin and easy to deform. Slowly insert the male-side piping straight in axial direction.
- Insert piping securely until a click is heard.
- After piping connection is completed, pull male-side piping by hand to make sure that connection does not come loose.
- Check for leakages when recharging refrigerant.