Removal and Installation

BRAKE BOOSTER PRESSURE SENSOR

Removal and Installation


REMOVAL

1.Remove master cylinder cover.
2.Remove brake booster pressure sensor.
3.Remove vacuum hose.

INSTALLATION

Note the following, install in the reverse order of removal.





- When installing vacuum hose, insert it until its tip reaches the back-end of length (A) or further as shown in the figure.





- Face the marking side vehicle front when assembling. (Brake booster side)

CAUTION:
Never use lubricating oil during assembly.
- Face the marking side connector when assembling. (Brake booster pressure sensor side)

CAUTION:
Never use lubricating oil during assembly.