Removal and Installation

COWL TOP

Removal and Installation


REMOVAL

1.Fully open hood assembly.
2.Remove front wiper arm (LH/RH) from vehicle. Refer to "Removal and Installation" Removal and Installation.
3.Remove battery cover and brake master cylinder cover.
4.Remove hoodledge cover mounting clips and then remove hoodledge cover (LH/RH) and cowl top cover seal (LH/RH).
5.Remove cowl top seal.
6.Remove cowl top cover mounting clips.





7.Plastic pawl (A) is pull up and cowl top cover RH (2) is removed ahead of vehicles.





8.Plastic pawl (B) is push down and cowl top cover LH (1) is removed ahead of vehicles.
9.Remove the following parts after removing cowl top cover.
- Front fender cover (LH/RH).
- EPT sealer.

INSTALLATION

Note the following, and install in the reverse order of removal.





- Install cowl top cover LH (1) with (C) (pin from front windshield glass) aligned with concave part.





- Slide the pawl while aligning with the concave part of (E).
- Engage the joint of plastic pawl of (A) with (D), and then assemble cowl top covers LH (1) and RH (2).

CAUTION:
After installing, perform adjustment of wiper arm. Refer to "Adjustment" Adjustments.