With Navigation

DIAGNOSIS SYSTEM (AV CONTROL UNIT)

CONSULT Function


APPLICATION ITEMS

CONSULT performs the following functions via the communication with the AV control unit.





AV communication
When "AV communication" of "CAN Diag Support Monitor" is selected, the following function will be performed.






ECU IDENTIFICATION

The part number of AV control unit is displayed.

SELF DIAGNOSIS RESULT

- In CONSULT self-diagnosis, self-diagnosis results and error history are displayed collectively.
- The current malfunction indicates "CRNT". The past malfunction indicates "PAST".
- The timing is displayed as "0" if any of the error codes [U1000], [U1010], [U1300] and [U1310] is detected.
The counter increases by 1 if the condition is normal at the next ignition switch ON cycle.
Self-diagnosis Results Display Item
















DATA MONITOR

NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
ALL SIGNALS
- Displays the status of the following vehicle signals inputted into the AV control unit.
- For each signal, actual signal can be compared with the condition recognized on the system.






SELECTION FROM MENU
Allows the technician to select which vehicle signals should be displayed and displays the status of the selected vehicle signals.






WORK SUPPORT

Adjusts the neutral position of the steering angle sensor.

CAUTION:
For vehicles with VDC, adjust the steering angle sensor neutral position on the ABS actuator control unit side.






CONFIGURATION

Configuration has three functions as follows.