Hazard Function

HAZARD FUNCTION

Description

Performs answer-back for each operation with number of blinks.


Component Function Check


1. CHECK FUNCTION

1.Use CONSULT to perform BCM "Active Test" ("FLASHER").
2.Touch "LH" or "RH" to check that it works normally.
Is the inspection result normal?
YES- Hazard warning lamp circuit is OK.
NO- Refer to "Diagnosis Procedure" .


Diagnosis Procedure


1. CHECK HAZARD SWITCH CIRCUIT

Refer to "WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table" Xenon Type Without Daytime Running Light System.
Is the inspection result normal?
YES- GO TO 2.
NO- Repair or replace the malfunctioning parts.

2. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END