Front Door Window Regulator: Adjustments

FRONT REGULATOR

Inspection and Adjustment


SYSTEM INITIALIZATION

Initialize the system if any of the following work is complete. Description.
Initialization
After installing each component to the vehicle, follow the steps below. Work Procedure.

FITTING INSPECTION

- Check that the glass is fit securely into the sash groove.
- Lower the glass slightly [approximately 10 to 20 mm (0.394 to 0.787 in)] and check that the clearance to the body side weather-strip is parallel. Loosen the regulator mounting bolts, guide rail mounting bolts, and glass and guide rail mounting bolts to correct the glass position if the clearance between the glass and body side weather-strip is not parallel.
- Raise the glass fully and adjust the glass top end and body side welt fitting with adjusting bolt (B), (C), or (D)
as shown in the figure below.