Removal And Installation

AIR BREATHER HOSE

VQ37VHR (AWD) : Removal and Installation


REMOVAL

1.Remove propeller shaft assembly (front). Exploded View.
2.Remove A/T air breather hose.
3.Remove propeller shaft assembly (rear). Exploded View.
4.Remove control rod from A/T shift selector assembly. Exploded View.
5.Support A/T assembly with a transmission jack.

CAUTION:
Be careful not to allow it to collide against the drain plug and overflow plug when setting the transmission jack.
6.Remove rear engine mounting member with a power tool. Exploded View.
7.Remove bolt fixing A/T assembly to engine assembly with power tool.
8.Remove air breather tube from transfer air breather hose. Transfer Assembly.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
- Never bend the A/T air breather hose to prevent damage to the hose.
- Insert A/T air breather hose to A/T air breather tube all the way to the curve of the tube.





- Be sure to insert it fully until its end reaches the radius curve end when inserting A/T air breather hose to air breather tube (for A/T) (1).





- Install A/T air breather hose to air breather tube (for A/T) so that the paint mark is facing upward.


- Securely install the clip to the brackets when installing A/T air breather hose to the bracket.