Telescopic Motor

TELESCOPIC MOTOR

Component Function Check


1. CHECK FUNCTION

1.Select "TELESCO MOTOR" in "Active test" mode with CONSULT.
2.Check the telescopic motor operation.





Is the operation of relevant parts normal?
YES- INSPECTION END
NO- Perform diagnosis procedure. .


Diagnosis Procedure


1. CHECK TELESCOPIC MOTOR POWER SUPPLY

1.Turn ignition switch OFF.
2.Disconnect telescopic motor connector.
3.Turn ignition switch ON.
4.Perform "Active test" ("TELESCO MOTOR") with CONSULT-III
5.Check voltage between telescopic motor harness connector and ground.





Is the inspection result normal?
YES- Replace telescopic motor (built in steering column assembly).
NO- GO TO 2.

2. CHECK TELESCOPIC MOTOR CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect automatic drive positioner control unit.
3.Check continuity between automatic drive positioner control unit harness connector and telescopic motor harness connector.





4.Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES- Replace automatic drive positioner control unit. Service and Repair.
NO- Repair or replace harness or connector.