Inspection and Adjustment

REAR SUSPENSION ASSEMBLY

Inspection and Adjustment


ADJUSTMENT BEFORE REMOVAL

Adjust neutral position of 4WAS front actuator. (With 4WAS) Work Procedure (Pattern 1).

INSPECTION AFTER REMOVAL

Check rear suspension member for deformation, cracks, or any other damage. Replace if necessary.

INSPECTION AFTER INSTALLATION

1.Check wheel sensor and harness for proper connection. Exploded View.
2.Adjust parking brake operation (stroke). Service and Repair.
3.Check wheel alignment. Rear Suspension Alignment Inspection.
4.Adjust neutral position of steering angle sensor. (Without 4WAS) Work Procedure.
5.Adjust neutral position of 4WAS front actuator. (With 4WAS) Work Procedure (Pattern 2).
6.Adjust levelizer adjustment of height sensor. (With AFS) Special Repair Requirement.